- Notes, Cautions, and Warnings
- Introduction
- Using Lifecycle Controller
- Operating System Deployment
- Monitor
- Hardware Inventory View and Export
- About View and Export Current Inventory
- About View and Export Factory-Shipped Inventory
- Viewing Hardware Inventory—Current or Factory-Shipped
- Exporting Hardware Inventory—Current or Factory-Shipped
- Viewing or Exporting Hardware Inventory After Part Replacement
- Viewing and Exporting Current Inventory After Resetting Lifecycle Controller
- Lifecycle Log
- Firmware Update
- Configure
- System Control Panel Access Options
- Configuring iDRAC
- Configuring System Time And Date
- Configuring vFlash SD Card
- Configuring RAID
- Configuring RAID Using Software RAID
- Creating a Secure Virtual Disk on Series 8 Controller
- Key Encryption
- Local Key Encryption Mode
- Breaking Mirrored Drives
- System Setup-Advanced Hardware Configuration
- Collect System Inventory on Restart
- Configuring Local FTP Server
- Configuring Local USB Drive
- Maintain
- Troubleshooting and Frequently Asked Questions
- Lifecycle Log Schema
- Easy-to-use System Component Names
- Using The System Setup and Boot Manager
Dell Lifecycle Controller 2 Release 1.4.0 User's Guide
Using Optional RAID Configuration
When you install an operating system, you can do one of the following:
- Deploy the operating system without configuring RAID.
- Configure the hard disk drives using the optional RAID configuration wizard and deploy the operating system.
Alternatively, you can configure RAID through the RAID configuration page from the .
Related tasks
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\